Just Wondering

[BLADEDADDY]

I posted a thread a couple of weeks ago looking for some help with my CX2 3 in 1 Controller. I see I have had quite a few views but not a single reply! Did I buy a newer version of the CX2 that has a different controller than most of the population using this forum?? Could anyone with a 4 in 1 Controller see if there is a small surface mount Voltage Regulator on your board and give me the alpha-numeric part numbers off it. this part is approximately 1/4" x 3/8" x 1/16" thick with three legs on 1 side and 1 thicker leg on the opposite side. Any help would be greatly appreciated.

I believe the two different boards will be utillizing the same regulator as this component provides the constant 5Volts for the servos, Receiver and provides the automatic low battery signal to the onboard processor to initiate the safety shut-down circuitry.

Thanks to anyone who could shed any light on this fo me.