 |
|
| Register | FAQ | PM | News | Events | Groups | Blogs | Calendar | Mark Forums Read |
 |
|
Unregistered
|
||||||
| MSH Protos MSH Protos Helicopter Support Forum |
|
|
 |
|
|
Thread Tools | Display Modes |
05-07-2012, 11:09 PM
|
#1 |
|
Registered Users
|
16T to much for the Turnigy 850.
Well, I tried a few packs today with a 16T on my Turnigy. 1300W max motor says, I was getting 1500+ Peaks at 65.3A 2700RPM. Guess it's a little much. Motor was pretty hot too. Sure sucked my batteries down. 8% after 5 min. So darn, back to the 15T I go
__________________
Dan Pesonen FBL, Don't think about it, DO IT. mCX2, nCPX, mCP X, Blade 400, MSH PRÔTOS "Tri-Flow" I put that S*** on everything!" |
|
|
|
«
Previous Thread
|
Next Thread
»
|
|
|
Unregistered
|
||||||
| MSH Protos MSH Protos Helicopter Support Forum |
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
