 |
|
| Register | FAQ | PM | News | Events | Groups | Blogs | Calendar | Mark Forums Read |
 |
|
Unregistered
|
||||||
| Mikado V-BAR Mikado V-Stabi/V-BAR Flybarless System Software and Hardware Support |
|
|
|
|
Thread Tools | Display Modes |
|
|
05-11-2012, 10:46 PM
|
#1 |
|
Registered Users
Join Date: Apr 2010
Location: Granbury
|
Change out full size for mini?
I just received my mini Vbar and started the setup. I am flying a 600ESP, a 600 Pro, a 700 and a Goblin, all with full sized Vbars on them. I will get my X7 next week and am wondering what experience everyone has had with the minis on a larger heli?
Would a mini work ok on the X7? I assume it is good for a 2S RX pack, and driving HV servos. I know I will have to add a "Y" harness to get 2 parallel power sources into it, but other than that, I am assuming the mini has the same sensor/software configuration as the full sized one, right? I really would rather not have to rip one out of my flying helis if I don't absolutely have to. Any help/ideas will be greatly appreciated. Thanks
__________________
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Goblin 700, Vbar Silver - Trex 700 V2, Vbar - Trex 700DFC, Vbar Silver - Gaui X7, Vbar Silver Trex600EFL Pro, Vbar - Trex 600 ESP, Vbar - Trex 500 ESP, SK 720 - DJI 550, GPS |
|
|
«
Previous Thread
|
Next Thread
»
|
|
|
Unregistered
|
||||||
| Mikado V-BAR Mikado V-Stabi/V-BAR Flybarless System Software and Hardware Support |
| Thread Tools | |
| Display Modes | |
Threaded Mode
|
|
