Washout hub

asasan · 05-21-2012, 07:20 PM

I used the hub that came with the FBL kit. It has a grub screw where the original (MSH51021) does not. The problem is the threads in this plastic unit all got stripped...the one for the grub screw and both washout/mixing arms.

The only washout unit available for purchase is MSH51021 which doesn't even have set screw hole. This whole unit doesn't seem to see a lot of load and all three screws seem to be holding well but if you turn them they will, to no end.

I wonder if it is OK to fly in this condition. Plus, I do not see how I can replace it where the only way to get my hands on one is to buy the whole FBL kit!!!

Any ideas?

05-21-2012, 07:20 PM	#1
asasan Registered Users Join Date: May 2011 Location: Berkeley, Cal.	Washout hub I used the hub that came with the FBL kit. It has a grub screw where the original (MSH51021) does not. The problem is the threads in this plastic unit all got stripped...the one for the grub screw and both washout/mixing arms. The only washout unit available for purchase is MSH51021 which doesn't even have set screw hole. This whole unit doesn't seem to see a lot of load and all three screws seem to be holding well but if you turn them they will, to no end. I wonder if it is OK to fly in this condition. Plus, I do not see how I can replace it where the only way to get my hands on one is to buy the whole FBL kit!!! Any ideas? __________________ mCPx, B450FBL w/ TarotZYX & Savox 255 MSH PRÔTOS CF FBL: YGE, Scorpion, JR3717HV, SK-720 w/ HBL980 JR X9503, TH SBach, Telink Edge, 3DHSExtra300SHP Last edited by asasan; 05-28-2012 at 03:15 AM..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode