Tail setup

[torch8]

Just want to reconfirm proper way to setup Tail?

- Set Tail servo horn as close to 90 degree.
- Set Tail pitch close to 0 degree on Tail Blades. Actually leaving a litte pitch on it ( I have Gaui 200/450d01)
- Set Gryo on radio to about 35% to Rate mode.
- Configure Tail endpoints for no binding.
- Make sure Tail blades returns back to zero pitch and align to each other.
- Make sure servo horns goes back to 90 degree
- Leave Rudder trim at center (netural).

Am I missing anything else?
It always seems that whenever I go to reconfigure my tail, after crash or changing tail parts. I have problem and heli always spins in circles. It takes me awhile to get it going.

[torch8]

Also when setting Tail endpoints, do you set it to get max range (most pitch) or just enough. I don't fly 3D yet so should I aim for most tail range without binding.

I have Gaui 200 and Walker 450D01. It seems when I choose most rudder range, heli would turn more than I want it? Would max range also cause excessive horizon tail wag, even with low gryo gain?