Power Jive Programming Question

Jamesppp · 06-15-2012, 07:01 AM

Let's say I have programmed my esc by doing a mode 1 reset, then programmed mode 4 and mode 9. Everything went as it is supposed to with all to es acknowledging the steps.

Later on I decide I need to program mode 10 in. Should it be ok to just add mode 10 without starting over with mode 1?!

I would like to know if this SHOULD work. I did this and the results were not good but I can't tell from the manual if this is something that should never be done
The manual does say the effects of the modes are cumulative or something lie that
Thanks

06-15-2012, 07:01 AM	#1
Jamesppp Registered Users Join Date: Feb 2008 Location: Carrollton,Georgia	Power Jive Programming Question Let's say I have programmed my esc by doing a mode 1 reset, then programmed mode 4 and mode 9. Everything went as it is supposed to with all to es acknowledging the steps. Later on I decide I need to program mode 10 in. Should it be ok to just add mode 10 without starting over with mode 1?! I would like to know if this SHOULD work. I did this and the results were not good but I can't tell from the manual if this is something that should never be done The manual does say the effects of the modes are cumulative or something lie that Thanks __________________ Compass7HV,Sk720HeliJive120HV Pyro 700 52L allHV Outrage 550: Scorpion 4020-1390,CC125A ESC,WR ESC Logo 5003D Scorpion Sk720 4020-1100, Blade130X MCPX TT E-620 SE x 2: Scorpion 4025-740 CCHV85 ,770/8900

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode