4gs motor in a mini cp?

gabeoravitz · 06-11-2012, 12:57 PM

I have an ESC and motor from a 4G6s. Think that'd work as an upgraded to the brushed motor? ESC is a 15A. Motor is 11,000kv and is the same size as the stock Mini CP's. Is it even possible to connect it all up?

gabeoravitz · 06-25-2012, 04:30 PM

No one has any input on this? after some searching, I think I've figured out that the power input on the ESC can be spliced to supply power to the RX right? The last question is, which of the 3 wires on the micro JST connector is the signal wire?

06-11-2012, 12:57 PM	#1
gabeoravitz Registered Users Join Date: Apr 2012 Location: San Diego, CA	4gs motor in a mini cp? I have an ESC and motor from a 4G6s. Think that'd work as an upgraded to the brushed motor? ESC is a 15A. Motor is 11,000kv and is the same size as the stock Mini CP's. Is it even possible to connect it all up?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-25-2012, 04:30 PM	#2
gabeoravitz Registered Users Thread Starter Join Date: Apr 2012 Location: San Diego, CA	No one has any input on this? after some searching, I think I've figured out that the power input on the ESC can be spliced to supply power to the RX right? The last question is, which of the 3 wires on the micro JST connector is the signal wire?