For sale: Futaba S9257 servo

[rchelijc]

For sale is a USED Futaba s9257 Servo

Asking $45 shipped anywhere in Australia.

Overseas buyers, it's $40+ shipping. PM me for a quote.

Story: This came used with my Protos 500. It had 2 servos: s9254 and s9257. At first I had the s9257 and I thought it was causing my tail wag issues. Then I chucked on the s9254, and the issue was still there. Long story short: I tweaked every thing possible. It wasn't the servo, or any binding in the tail, or the governor, or the beastX. It was my stupidity: I had assembled the thrust bearings in the tail grips wrong. Once done, the tail was perfect, but I don't want to touch the tail now that it's good, so whatever was on stays on.

The s9257 was off, so it's for sale. Pictures at the bottom.

Specs below, copy and pasted:

• Control System: +Pulse Width Control 1520usec Neutral
• Required Pulse: 3-5 Volt Peak to Peak Square Wave
• Operating Voltage: 4.8 Volts Only
• Operating Temperature Range: -20 to +60 Degree C
• Operating Speed (4.8V): 0.08sec/60 degrees at no load
• Stall Torque (4.8V): 27.8 oz/in. (2.0 kg.cm)
• Operating Angle: 45 Deg. one side pulse traveling 400usec
• 360 Modifiable: Yes
• Direction: Counter Clockwise/Pulse Traveling 1520-1900usec
• Motor Type: Coreless Motor
• Potentiometer Drive: Indirect Drive
• Bearing Type: Ball Bearing
• Gear Type: All Nylon Gears
• Connector Wire Length: 7.9"
• Dimensions: 1.40" x 0.59"x 1.13" (35.5 x 15 x 28.6mm)
• Weight: .92oz. (26g)