Align 600 DFC head - Page 4

Carapau · 04-03-2012, 10:02 AM

Compass head turned up today and is nearly fitted. I have started a new thread for that head to help with future reference. Here is the link.

Blackbird1 · 04-04-2012, 04:47 AM

What link rods you use to fit the align dfc head in the fusion? Because the dfc ones i think is too sort.

seemore74 · 04-05-2012, 12:26 AM

I bought 2 lengths of about 5mm threaded studs as this was the shortest they had in my local hobby shop. I then cut it about 3.5mm so a good length was screwed up in the DFC pitch rod. I also had to buy from them 2 plastic ball links that would normally be used on large planes link rods as the outrage ones are too small to be used on 3mm studs & the supplied align ones are slightly too big for the outrage balls (they pop off easily).
So far a much more cost efficient route compared to the Compass version of the rigid style head that is holding up VERY great without any probs

Jotto · 08-19-2012, 03:25 PM

seemore,

sorry for waking up an old thread, but is the DFC mod still working ok for you?

04-03-2012, 10:02 AM	#61
Carapau Registered Users Join Date: Jan 2011 Location: God's own county. Ay oop lad, tek care lambs ont road	Compass head turned up today and is nearly fitted. I have started a new thread for that head to help with future reference. Here is the link. __________________ Rush 750, Vbar, 9188, BLS157HV, Kosmik 160, 4525 Ult Fusion 50, Vbar, 9188/80s, Helijive & Quantum 4135 motor, Mini Protos DS95s/95i, Ice Lite 50, mini v Trex 450 Pro DS95/95i, Mini V, RJX head, Ice 50 Lite, 6s 2221-2010 DX18

04-05-2012, 12:26 AM	#63
seemore74 Registered Users Join Date: Dec 2008 Location: london	I bought 2 lengths of about 5mm threaded studs as this was the shortest they had in my local hobby shop. I then cut it about 3.5mm so a good length was screwed up in the DFC pitch rod. I also had to buy from them 2 plastic ball links that would normally be used on large planes link rods as the outrage ones are too small to be used on 3mm studs & the supplied align ones are slightly too big for the outrage balls (they pop off easily). So far a much more cost efficient route compared to the Compass version of the rigid style head that is holding up VERY great without any probs __________________ Shape 9.0, Goblin 700 (yellow & orange) , Outrage G5 all FBL MKS Cyclics & Rudder Servos all round. Futaba SBus Rx, Futaba 8FG transmission.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-04-2012, 04:47 AM	#62
Blackbird1 Registered Users Join Date: Apr 2009 Location: GREECE	What link rods you use to fit the align dfc head in the fusion? Because the dfc ones i think is too sort.

08-19-2012, 03:25 PM	#64
Jotto Registered Users Join Date: Aug 2007 Location: Oppegård, Norway	seemore, sorry for waking up an old thread, but is the DFC mod still working ok for you?