450 v2 3d set up a comments and suggestions all taken in to consideration

[edoyle11]

i had a quick question im flying a trex 450 v2 and starting to set up for 3d stock motor and esc hs65hb servos and algin 500 gryo and hs 85bb tail servo im running tro curve at 100 95 90 95 100 and picth curve 0 25 50 75 100 and blade picth and 9 neg and 10 positive. when in 3d mode its wobbles a bit on the ground when i get it up its steady but when going inverted it just seems a bit hard to control (little to no wind) and it also seems to take just a bit more than half stick to lift off the ground any comments or suggestions would deff be helpfull thanks guys

[edoyle11]

i forgot to mention im using a dx61 with a spektrum ar6200 reciver

[Beaver Rat]

What form of wobble, tail, head...?

[edoyle11]

just a bit of head wobble i replaced my orings but still getting just a bit only while its on the ground

[jhat]

What size is the pinion, do you have enough head speed? Seems to be consensus that most but not all fly either a 12t or a 13t with the stock motor

[edoyle11]

13t and yeah i have enough head speed im at 90 percent blades are perfectly balanced and all new shafts ect.. its not mecanical i dont think