Fun, Learning, Friendship and Mutual Respect
START  HERE


Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Bergen R/C Helicopters


Bergen R/C Helicopters Bergen Intrepid 90 Intrepid Turbine Observer Industrial Twin Observer Turbine Support Forum


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-19-2008, 07:50 PM   #1
SeaHawk
Registered Users
 
Posts: 344
 

Join Date: Mar 2005
Location: US
Default stripped zenoah muffler bolt hole

I know, this isn't a Bergen issue, but has anyone else had problems stripping the stud hole out of the engine? I've done it a couple of times. One would imagine that I was using too much Gorilla Wrench on it, but I'm just using an old OS engine flat wrench filed down on one side to fit. I can only get a thumb and an index finger on it and I don't feel I'm over tightening.

I've dropped Chris a PM asking if this is the right helicoil. I'd appreciate someone who knows about the proper size taking a look and validating part size at this line http://www.amazon.com/Metric-Coarse-...8&s=automotive

Anyone ever try JB weld or manage to put a nut on the 'back end' of the stud (I'm on my way to the basement to see if that's a possibility)

Thanks
SeaHawk is offline        Reply With Quote
 




Unregistered
Go Back   HeliFreak > R/C Helicopter Support > Bergen R/C Helicopters


Bergen R/C Helicopters Bergen Intrepid 90 Intrepid Turbine Observer Industrial Twin Observer Turbine Support Forum

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


Copyright © 2004-2011 - William James - Helifreak.com