SpartanRC DS760 Gyro Review and Setup Vids

Brady Miceli · 11-12-2008, 08:26 AM

"Starting from firmware version v1.07 the gyro will not start calibration until the gain is raised above 15% (either AVCS or Rate mode). Spektrum users should bind their radios while the gain is set to a value around 10% preferably in AVCS. This becomes the default gain output when the receiver is powered on which will now prevent the gyro from starting calibration until the link with the transmitter is established. This method of setting low gain is preferred over binding with the rudder stick off center which will become obsolete in future firmware revisions."

So if my gear values are set at 45/45 this should enter setup mode?
How is 10% calculated?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-12-2008, 08:26 AM	#11
Brady Miceli Registered Users Join Date: Nov 2007 Location: SCS, Michigan	"Starting from firmware version v1.07 the gyro will not start calibration until the gain is raised above 15% (either AVCS or Rate mode). Spektrum users should bind their radios while the gain is set to a value around 10% preferably in AVCS. This becomes the default gain output when the receiver is powered on which will now prevent the gyro from starting calibration until the link with the transmitter is established. This method of setting low gain is preferred over binding with the rudder stick off center which will become obsolete in future firmware revisions." So if my gear values are set at 45/45 this should enter setup mode? How is 10% calculated?