How to enable TH on RF 7.5?

[BladeScraperz]

Good evening guys, just installed the RF 7.5 and can't figure out how to enable TH? Any suggestions would be much appreciated thanks!

[JonJet]

I have RF 7.5 with the InterLink controller...

TH operation was there when I needed it, no setup required

[BladeScraperz]

Originally Posted by JonJet

I have RF 7.5 with the InterLink controller...

TH operation was there when I needed it, no setup required

Hmmmmm.....Mine doesn't do anything when I flip the hold switch? Using a dx 7s and dx9

[JonJet]

Did you do the controller calibrations?

[BladeScraperz]

Yes and the controls move but the hold swith didn't move on screen

[JonJet]

If you are the original owner, I'd say you need some customer service

[BladeScraperz]

OK I'll call them tomorrow thanks

[alyon187]

I have a semi same issue... check your other switches, mine is set to the gov switch on my dx8 for some reason. Just haven't gotten around to changing it yet

[ArchmageAU]

<shakes head>

What did you want hold to do? Drop throttle to 0?

If you are using a DX7, 8, 9, etc... What is your throttle curve and do you have your hold switch set to send throttle to 0? (Ideally you want to bypass the software radio, also bypass software radio DR/expo so you can control it all in your transmitter).

With the interlink, the hold switch is channel 7 input. When engaged, the software radio drops the throttle to 0.

Hope this all makes sense.