Register Now

Roryw · 05-19-2011, 02:09 AM

What setup are you using to get the blue light at 6 degrees.

Shorter servo horns or ball links ?

I know it is not needed, but preferable.

Thanks
Rory

Anthony440 · 05-19-2011, 02:45 AM

You need to move the ball closer to center of the servo. I think it is a good idea since it's going to be easier on your servos. It will give them better leverage to take the load of a fbl geometry.

FurryTrex · 05-19-2011, 06:17 AM

I have my balls on the servo arm according to the 3G FBL manual.

Also in the manual, be sure to change the balls on the inner swash plate ring, to the very short ones(very little to none stand-off balls.

just check the 3g manual, and examine the swash plate, you will see the difference...

05-19-2011, 02:09 AM	#1 (permalink)
Roryw Registered Users Join Date: May 2006	Trex 550 - Blue Light for 6 degrees? What setup are you using to get the blue light at 6 degrees. Shorter servo horns or ball links ? I know it is not needed, but preferable. Thanks Rory

05-19-2011, 06:17 AM	#3 (permalink)
FurryTrex Registered Users Join Date: Sep 2009	I have my balls on the servo arm according to the 3G FBL manual. Also in the manual, be sure to change the balls on the inner swash plate ring, to the very short ones(very little to none stand-off balls. just check the 3g manual, and examine the swash plate, you will see the difference... __________________ My tutorials: Trex 250 Carbon Fiber Tail Push Rod https://www.helifreak.com/showthread.php?t=238095

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-19-2011, 02:45 AM	#2 (permalink)
Anthony440 Registered Users My HF Map location Join Date: Jul 2009 Location: Colorado	You need to move the ball closer to center of the servo. I think it is a good idea since it's going to be easier on your servos. It will give them better leverage to take the load of a fbl geometry.

Register Now

Log-in