WHAT HV RX TO USE WITH A 10C

[MattJenner]

Hi
What RX can I use with the 10C which will run using a 2 cell lypo (7.4)
the normal 14 channel is rated at 6 volt only. I want to directly connect without the use of regulators.
I only want a step down for the Gyro.

[dvelez3]

With the 10C you can use all of the Futaba's FASST RX's, they will all be ok with a 2 cell Lipo including the 14 channel rx. You need to worry about the servos that can handle a 2 cell lipo pack, the receivers will be fine.

Doug

[MattJenner]

Hi Doug,
Many thanks for answering my question.

When you say FASST do you mean FASST only, I have a couple of RX that have T-FHSS AIR


Can I use this RX with the 10C - Futaba 6208SB rx

[dvelez3]

Hi Matt,

The 10C can only use one protocol and that is FASST only. For now, only the 10J can use the T-FHSS receiver.

The Futaba 6208SB rx is a FASST receiver so it works with the 10C.

Check the bottom part of this page for receiver compatibility. http://futabarc.com/receivers/air.html

Hope that helps,
-Doug

[dotharth]

Hi,

2S lipo is not 7.4V but 8,4V at full charge. So make sure you use compatible servos if you plan to use 2S unregulated

The 6208SB is compatible 8.4V