Need advise on my 600SE

[celm]

i jsut go 600SE from someone and these are the specs when previous owner was flying it

jive 80 esc
5020-450kv scorpion with 14 tooth pinion
running 693 mains with 1800 headspeed

he said he was running 4500 mah 10S lipos

i want to put 603 size mains and run a headspeed of 1800 to 2000.
so is it possible to run those blades with that size and kv motor?
i also have alot of 12S lipos,and no 10s`s. so could i run 12S in that?

thanks guys

[Mentalic]

You can run that gear on 12s but need to change the pinion to 11t.

[celm]

Originally Posted by Mentalic

You can run that gear on 12s but need to change the pinion to 11t.

but say i do want to run a 10S and 603 mains. then the pinon is fine?
is the SE tail boom to long for the 603?

[celm]

but say i do want to run a 10S and 603 mains. then the pinon is fine?
is the SE tail boom to long for the 603?

[Mentalic]

Originally Posted by celm

but say i do want to run a 10S and 603 mains. then the pinon is fine?
is the SE tail boom to long for the 603?

You could run 10s but you will need to run a low governor setting. The Jive can handle it without issue.

Mr Mell's handy tool for figuring this sort of stuff out:
http://heli.dacsa.net/calcv3/

The tail will work its just going to be long and you should use 95mm tail blades when over 1900 rpm or replace the stock tail.

[celm]

my jive is set on mode 4