FlyCamOne Eco V2 firmware update guide

[JonnyKango]

Seems many people online are having problems with this. The manual instructions are seriously lacking, and the README.txt in the download is abit vague also.
So now i have mine sorted, thought i'd share

Steps:

1. Download the firmware zip file from here: http://www.flycamone.com/acme2010/do...Oe/01_FCOe.zip

2. Unpack THE WHOLE zip file (make sure the .bin file is there too) to a folder of your making (i didn't do this first time and ran into problems ie 'cannot start device')

3. Install the file "STKO2H 2.O Reinstall" [run as admin on Vista]. Ignore certification warnings (note STKO2H [no 'U' in the filename]) - IMPORTANT you may get a malware warning from your virus protection, go ahead and add to exeptions or click ignore!!

4. Restart your PC

5. goto control panel/programs and features and confirm that STKO2H 2.0 is installed

6. confirm that the switch on FCOeV2 marked on/off is 'OFF'

7. connect power to FCOeV2 - either via your BEC system (RX port) or by 1 cell lipo external battery

8. WHILST HOLDING the white button in the corner of your board on FCOeV2, connect the USB between FCOeV2 and your PC

9. give windows a few secs to install the driver for the cam, when windows confirms installation.......

10. run the other EXE in the zip folder named: "STKO2HU-Reinstall" (note the 'U' and dash in filename) [run as admin on Vista]

11. you should now be faced with a screen, prompting a confirmation, click 'update'

12. if all went well, you should now have a screen with two pull down menu's - DRAM timing and DRAM size, set them to:

DRAM timing 0x35
DRAM size 8M

13. confirm and wait for 30-40 secs, and confirmation of correct update will be displayed

Hope this helps someone, any questions, i'll help if i can

This was done on Vista Ultimate x86

Happy flying

[Jungle Bob]

Thanx, I have had a Flycam v2 sittng around for a while which I haven't used. I may follow your instructions and get the thing up and running - cheers