START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
2.4G Spektrum Radios Spektrum 2.4 Gigahertz Radios and Technology |
|
LinkBack | Thread Tools | Display Modes |
12-27-2013, 10:11 AM | #1 (permalink) |
Registered Users
Join Date: Nov 2013
|
Spektrum Dx9 Questions
Hi I Just bought the dx9 till now all i can say it amazing transmitter but i can find any videos about setup helicopter with this tx how to swash mix etc... throttle cut , idle setup etc ... , any one know where i can find some videos i know about the manual but for me it's not that good i need to see some one do it on video . Thanks For your help
Best Regard Wayne |
Sponsored Links | |||
Advertisement |
|
12-27-2013, 10:26 AM | #2 (permalink) |
Registered Users
Join Date: Mar 2013
|
You don't need DX9-specific videos for that, DX8 is exactly same setupwise. You can however do binding from DX9 menu but regarding setup that's about the only difference.
Plenty of videos for DX8 so You'll be ok |
12-27-2013, 11:22 AM | #4 (permalink) |
Registered Users
Join Date: Sep 2008
Location: Smyrna, GA
|
Also note, the software is the same between the DX9 and DX18, so the file uploads are compatible between the two using the SD card.
As was stated, the menu and basic functions are similar to the DX8. You will find more information in the Spektrum specific forum https://www.helifreak.com/forumdisplay.php?f=33
__________________
Tony Synergy 516, Gaui R-5 Speed (RIP), Cypher Vtol Jet (RIP), Spirit FBL, Hobbywing and Scorpion Tribunus ESC, Xnova motors. The girl in my DX9 tells them all what to do |
12-27-2013, 07:16 PM | #5 (permalink) |
Registered Users
Join Date: Nov 2013
|
I just set up a Blade 450 3D on a DX9 and maiden flight was tough. I used the settings for the DX8 and it needed lots of trim back and to the right. Also the gyro gains were too low. Of course this nice combination turned a hover attempt into a very exciting recovery as I wrestled to get it back while watching the tail drift all over the place.
I'm hoping for some DX9 specific settings soon. Til then hold on for a wild ride as you figure it out. I may need to start learning how to set everything manually soon. |
12-28-2013, 08:51 AM | #6 (permalink) |
Registered Users
Join Date: Sep 2008
Location: Smyrna, GA
|
Learning what the features on a computer TX do and how to use them is a must! The TX is one of your most powerful tools, and you will be shorting yourself just trying to copy what someone else uses into your model, which will rarely work anyway. A heli that needs a lot of trim to hover is a heli thats head and tail wasn't set up correctly mechanically first.
No two models are identical, even if they are the exact same model. Different mechanical setups will cause one model to react a little differently than the other. Read everything you can regarding your TX in the Spektrum forum, plus watching the TX and basic heli pre flight setup vids from Finless on the DX7, etc and they will tell you what the different features do and how they work. The menus may not look exactly the same, but the basic functionality of the different features and what they do is the same across all TXs. There is a learning curve that must be overcome initially when working with a computer TX for the first time, but its one that is very rewarding once you understand it, and its a necessity setting up any heli.
__________________
Tony Synergy 516, Gaui R-5 Speed (RIP), Cypher Vtol Jet (RIP), Spirit FBL, Hobbywing and Scorpion Tribunus ESC, Xnova motors. The girl in my DX9 tells them all what to do Last edited by Xrayted; 12-28-2013 at 10:08 AM.. |
12-28-2013, 11:55 AM | #7 (permalink) | |
Registered Users
Join Date: Nov 2013
Location: Aberdeen, UK
|
Quote:
As per advice in above post, I think you are right that you should learn to set up manually, blindly uploading set up data without ensuring the basic mechanical set up is right will end in tears sooner or later (most likely sooner). |
|
02-01-2014, 02:03 PM | #8 (permalink) |
Registered Users
Join Date: Jan 2014
|
Not the Same
I'm new to the hobby as well, and also have a DX9. Also finding nothing out there for setup with specifically Blade heli's. Hate to disagree, but the DX8 is not exactly the same. I haven't gone through ever menu yet, but off the top of my head is the F-Mode menu. Not totally sure on this point, but I do know that the DX9 has 7 point curves, throttle, pitch, etc. where I believe the DX8 and earlier TX's only have 5 points. And of course there is all the voice menus. I wish, specially since Spektrum, and Blade are both Horizon Hobby that they would put more stuff out there on YouTube for configuring the DX9 for different heli's. Only thing I've found is the one for the 350QX which was extremely helpful since I have one.
|
Thread Tools | |
Display Modes | |
|
|