Fusion 50 motor support bracket supposed to be threaded on both sides?

[AnTi Taco]

ok im putting on my motor support bracket and i noticed the wider half of the bracket has no threads in it for the 8mm long screw like the smaller half does and the manual just shows that you put the 4 screws into the support bracket to secure it... and i don't see anything about using a bolt to hold it on...so im thinking maybe there supposed to be threaded holes on all four instead of just 2 like min are??? but even if it was it wouldn't hold it in place cause the bigger side of the bracket is of the outside of the frame so threads wouldn't do anything...maybe i missed something in manual

[AnTi Taco]

Duh you need to bearing block to complete the assembly of the motor mount..:o