Genius Cp V2 RX2644H-D

[tonyboy459]

Hi
I have a genius cp v2 with a RX2644H-D Receiver. The LED is flashing red and green what does that mean. Does it indicate a certain mode? If so how do I change between the modes. The receiver does not have dip switches on it like the V1 receiver.

[Arizona Shorty]

For what it is worth, the only mention I find of red and green alternate flash is when the transmitter has bee set to test mode. In my manual for the v2, the discussion is on page 8, section 6.3(1) and/or (2) depending on which tx you have. Hope this helps, but likely you figured it out a while back as it has been several weeks since you posted.

[tstivers]

May not be the case with the genius but my mini cp flashes red/green when throttle hold is enabled. At least with the stock firmware on the tx it does. It stopped after I switched to deviation.

Sent from my XT1028 using Tapatalk

[Heli Yea!]

Originally Posted by tstivers

May not be the case with the genius but my mini cp flashes red/green when throttle hold is enabled.

Sent from my XT1028 using Tapatalk

+1 My Mini CP does the same when throttle hold is on. I use stock firmware.