Help Beastx

[wperry38]

anyone know why the motor will not start. it was was working good. it was a standard set up.Trex 700E.
Jr 9503. throttle hold was working been flying it for 6 mos. put the beastx in all tuned up looks like it works ok,but no start. I did not change anything on the throttle esc.?
Bill

[LARRY2716]

On gear to use switch and travel adjust. On Aux 2 if wish to use Gyro menu. If on Aux 2 can disable gyro menu and use Aux 2 switch if desjred. The JR can only use AUX 2 with gyro menu.

Sent from my DROID BIONIC using Tapatalk

[wperry38]

thanx larry. I got it now. I got a new problem now. the heli motor won't start up. did not change anything to do with throttle in the radio.
Bill

[Bob O]

If you want to use the Gear channel for gyro gain, you may also do it via the Gov menu. Works the same way as Gyro Sense on Aux2.

As far as the motor not starting, I'm a nitro guy so I can't help much there. Others will chime in I'm sure. It's got to be something simple, IMO.

[Ah Clem]

Will the X9503 allow you to use Channel 5 (Gear) for the gyro sense menu?

The 9303 would not let you do so, you had to use Channel 7 or above.

[wperry38]

aux 2 on the 9503

[scott s]

here is the perfect solution again guy's. this is ideal in my opinion! 9503 is the exact same. plus you will have flightmode independent gains and rate mode switchable. Great for centering your tail slider after carrying to flight line or if you fly rate once in a while! PLUS if you go to the ar7200bx you have no choice but to use channel 5 (gear) with it!!!

Attached Files9303_mixing.pdf (208.1 KB, 100 views)

[LARRY2716]

If ESC is not arming then must not be seeing 0 throttle.
See that throttle trim has not moved and throttle curve ok.
Rebind.

[wperry38]

thanks guys. I found the prolbem. the copy of my 700e model was bad. I built a new clean model and the esc works the motor.
now I found out the gyro gain does not work. so I am working on that now.

[LARRY2716]

At least the lights on the Beast make it easy to see if gain and gain adjustment is working.

[Bob O]

Originally Posted by LARRY2716

At least the lights on the Beast make it easy to see if gain and gain adjustment is working.

+1

If you're making again adjustments in the transmitter and they lights aren't changing on the MB, either something is wrong with the transmitter setup or the signal lead connection, or both.