UniSense - E and 14SG / R7008SB

[KC8CYF]

Hello Fellow Members,

Anyone have success with setup of SM Modell Bau UniSense-E telemetry sensor and 14SG with R7008SB? I think I followed the setup and wiring correctly, but am not receiving any data on the S.Bus-2 Telemetry

I've setup my UniSense with the OEM software (UniSense-E Tool 1.0.7) and updated my device to the current FW revision of 1.11

I've also set the sensor for "fixed serial number" per the manual
in the revision notes: "5. new option "fixed serial number" sends the serial number 12345 via telemetry at Jeti and Futaba -> so that sensors can be interchanged and may not need to be programmed again"

UniSense Telemetry Link Connector & Cable is plugged into the R7008SB S.Bus-2 Port


Questions:
1) Do I still need to register the sensor using the Futaba procedure with the S.Bus-2 programming S-I/F (sensor interface) port? I've "registered" each sensor with the "12345" code in the Telemetry setup menu already.

2) According to the manual I don't need to terminate the second "link" signal wire... this is used to trigger Min, Actual and Max readings... leave open if not used?


Thanks!

[KC8CYF]

See my questions in the 2.4Ghz sub forum

Looking from help from any experienced users of the UniSense telemetry device.

Thanks!

[KC8CYF]

Case closed

You must register the sensor using the Futaba S-I/F port on the back of the radio even when selecting the "fixed serial number" option in the UniSense software.

Sensors are working now. Altimeter, Vario, Temperature, RPM, Voltage, Current and most importantly mAh consumed!

UniSense Rocks!

[KC8CYF]

Case closed

You must register the sensor using the Futaba S-I/F port on the back of the radio even when selecting the "fixed serial number" option in the UniSense software.

Sensors are working now. Altimeter, Vario, Temperature, RPM, Voltage, Current and most importantly mAh consumed!

UniSense Rocks!

[TowPilot]

Please do not cross post.

Merged.

Thanks in advance,
Mike