Register Now

MallenP · 06-29-2015, 10:16 AM

My question is if this servo is too big as a tail servo for my 360CFX, it says it should work for a 450 tail but I can't seem to get it fit dialed in, it either stops too hard and bounces back and starts wagging, or stops are too soft and the tail keeps turning

macdad · 06-30-2015, 05:21 AM

I don't have the 360CFX, but... I assume you are adjusting the gain and to get the different stop results? If so, are you getting that much difference by changing the gain setting by only 1 point?

How far is the ball from the center of the servo? If you are getting that much variation with just a click of gain, you probably have too much mechanical gain. The ball may be too far from the center of the servo.

06-29-2015, 10:16 AM	#1 (permalink)
MallenP Registered Users Join Date: Jan 2015	Savox SH-1250MG My question is if this servo is too big as a tail servo for my 360CFX, it says it should work for a 450 tail but I can't seem to get it fit dialed in, it either stops too hard and bounces back and starts wagging, or stops are too soft and the tail keeps turning

06-30-2015, 05:21 AM	#2 (permalink)
macdad Registered Users Join Date: Jan 2014	I don't have the 360CFX, but... I assume you are adjusting the gain and to get the different stop results? If so, are you getting that much difference by changing the gain setting by only 1 point? How far is the ball from the center of the servo? If you are getting that much variation with just a click of gain, you probably have too much mechanical gain. The ball may be too far from the center of the servo. __________________ Oxy 2, Gaui X3 #1, Protos 380, Gaui X5, Synergy 766, Specter 700 Oxy 2/X3/Protos 380/X5/766/Specter 700 Consecutive Successful Flights (Current) = 32/16/12/145/7/50 Consecutive Successful Flights (Max) = 145

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in