What receiver do i need with futaba 10CHG?

[amitt]

very confusing and just getting into this..

will be using gyro obviously (does this connect to rx with sbus?)

should i get the R6014HS or something like the R6208SB thru R6203SB series?

thanks

[JoseVazquez35]

The R6014 HS i think is the 12 channel thats the one you want

[scotty82]

For use with a CGY750 I would use a R6203SB. Or I would get a R6208SB which is 8 channel plus SBUS.

The receivers that end with HS are FASST high speed receivers. They dont have SBUS capability.

[ClubCRASH]

Go see at the bottom of the following link:

http://futabarc.com/receivers/air.html

[theColonel]

it really depends on what you are putting it in.

R6014HS
If you have a scale heli with a fly bar that needs more than 8 channels, for lights, retracts etc. this is your only option. (You will still be able to convert to a flybarless system in the future (or use one now!), however you'll have more wires than with an SBUS system, as per below).

R6208SB
This is the best option if you need a couple of spare channels, or have a flybar heli. You'll have enough channels for most applications and a couple spares for retracts, governors, cameras etc.
You also have the option to use SBUS for flybarless controllers, if you have or are planning on buying one in the future.

R6203SB
If you are already flybarless, the R6203SB is the cheapest option. The SBUS output will go straight to your flybarless controller for a very simple setup. If you have a flybar heli, this is not a good option.
Note: with the 10CHG you can't reassign channels, so channels 1 to 3 will always be aileron, elevator and throttle, so controlling any additional items would require an SBD-1 or an SBUS servo, neither of which are particularly cheap.

[theColonel]

Originally Posted by amitt

will be using gyro obviously (does this connect to rx with sbus?)

No, not normally. You'll need to connect it to channels 4 and 5. 4 is the rudder and 5 is the gyro gain.

[amitt]

thank you. got the R6203SB for FBL system