Wookong question

[rcflyerheli]

I am trying to set up a Wookong M with camera gimbals. I have the camera pitch figured out, but the roll function doesn't seem to be working. I am running the Savox 264MG servos with the pitch servo connected to F2 and the roll servo connected to F1.

I get proper pitch functions using the X3 channel to control the pitch servo and I can change the pitch of the camera mount with the rotary knob as per the manual. However, the roll servo doesn't appear to be getting any signal, as I get no roll stabilization and the servo output arm can be rotated with power applied.

Does anyone have any ideas how to get the roll function to operate?

Update:

Disregard, I got it to work.

[Thalios]

Do you have anything assigned to x3? Check the gain controls, etc.

[Thalios]

Also make sure you don't have switch activated RTH.

[rcflyerheli]

Thanks for the reply. I had it set up correctly, as I was getting the pitch channel to work fine, I just couldn't get anything out of roll. I went back and looked at the servo connectors that plug into the MC, and the Savox plugs are (was on the roll) loose. I got them inserted good and put a dab of hot glue to hold them in, and everything works as normal.

I'm not positive how smooth the roll is going to be, and I might have to make some mechanical adjustments to the servo arm setup.