Master CP blade tracking

[topcat1]

I set my blades to 0.00 degrees at mid-stick by adjusting the ball links, now the blades are not tracking properly. If I use the ball links to make the blades track as one then won't that put the pitch of the blades out of whack? How do you remedy this issue.

[Pachapapa]

Hi

did you first level you swash plate with servos @90° (with linear pitch curve from 0 to 100%) ?

[topcat1]

Yep!

[Pachapapa]

Your blades may be twisted so ...

[Livan75]

If swash is leveled, the blades are tracking but the pitch is off, raise or lower the entire swash by shortening or making all three rods longer by the same amount until you get zero pitch....

[topcat1]

Thank you I will.