START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
SR Blade Helicopters (eFlite) SR |
|
LinkBack | Thread Tools | Display Modes |
08-07-2015, 08:20 AM | #1 (permalink) |
Registered Users
Join Date: Aug 2015
|
Lots of DX7 but no DX7s setups??
I've been searching through the forums for a setup for a DX7s on an SR, but am having no luck. Anyone have one setup with the 7s as it looks to be that the programing is slightly different between the DX7 and the DX7s.
Also, was pointed to these forums for downloadable programs and am having trouble locating them also. Any help is greatly appreciated!! |
Sponsored Links | |||
Advertisement |
|
08-08-2015, 09:51 AM | #2 (permalink) |
Registered Users
Join Date: Mar 2014
|
You may need to experiment some and use DX7 settings and go from there. It's what I had to do on my DX8.
__________________
Blade: Nano QX, SR, 230s, 400 3D Walkera: V120D02s Align: 450L Dominator, 450 Pro DFC, 500 Pro DFC |
08-10-2015, 01:01 AM | #3 (permalink) |
Registered Users
|
I use a DX7S with my SR and its easy enough to get going.
Shout back with what you need to know.
__________________
Nigel. A few little tiddlers ..SR, 300X, TRex 500E Pro with DFC, Trex 700DFC..... and quite a few Planks and Tanks ! |
08-30-2015, 11:05 PM | #4 (permalink) |
Registered Users
Thread Starter
Join Date: Aug 2015
|
So, I got the dx7s bound and set up-ish. Response seams to be slow on the controls tho. My dual rates off a bit possibly?
|
08-31-2015, 10:56 AM | #5 (permalink) | |
Registered Users
Join Date: Mar 2014
|
Quote:
Flew nice for a while, then I must have gotten a gremlin in it. All the sudden it started trying to re initialize everytime I initialized the heli. ESC started getting really hot, replaced a servo I thought was the culpret But ended up replacing all with Hitech 65's. After that the heli was outta control. Could barely keep control of it, and like you it seemed I had to slap sticks a lot farther than before. (Adjusted DR&EXPO and couldn't calm it down) Still no corrections to its wild behavior! Rebound it to my DX6i, and set the head up again and it was much better controllable....but the tail now is a slappy mess! It twitches from side to side pretty bad, I can get that calmed down some but when I do then I have a good bit of drift to the right on the tail. I don't know what in the world happened to it! :-((
__________________
Blade: Nano QX, SR, 230s, 400 3D Walkera: V120D02s Align: 450L Dominator, 450 Pro DFC, 500 Pro DFC |
|
Thread Tools | |
Display Modes | |
|
|