Register Now

Jason O'Connell · 07-18-2014, 10:15 AM

did you ever remove and check the bearing stack on the old setup?

joecass2 · 07-18-2014, 06:58 PM

yes I did check the bearing stack the only thing I did notice was I had a very small washer on the 3mm nut the instructions did not show that washer. but they did show a washer in between the thrust bearing and the bearing closest to the hub. I did not have this washer. I did not bother to order the washers because I had the tail rotor on order already.

I never changed the plastic grips on the original tail rotor.

thanks for the help guys

07-18-2014, 10:15 AM	#21 (permalink)
Jason O'Connell Formerly BarnStormer Join Date: Aug 2008	did you ever remove and check the bearing stack on the old setup? __________________ Scorpion Power Systems

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-18-2014, 06:58 PM	#22 (permalink)
joecass2 Registered Users Thread Starter Join Date: May 2006	yes I did check the bearing stack the only thing I did notice was I had a very small washer on the 3mm nut the instructions did not show that washer. but they did show a washer in between the thrust bearing and the bearing closest to the hub. I did not have this washer. I did not bother to order the washers because I had the tail rotor on order already. I never changed the plastic grips on the original tail rotor. thanks for the help guys

Register Now

Log-in