Setting up a Blade 400 with a Futuba R607FS Reciever

[ajcali96]

I'm a newbie and I was needing some help. I am wanting to use my Futaba 6EX transmitter and R607FS receiver on my Blade 400 and didn't know where to start. If anyone has any info on where what goes in the receiver please let me know. Sorry for the stupid question. Thanks

[drakenn]

1 - Aileron
2 - Elevator
3 - Throttle
4 - Gyro
5 - Gyro Gain
6 - Pitch

Edit:
Servos 1,2 and 6 may take some flipping around to get them in the right slot. Also as RoboKopter mentioned for most ESC's with a futaba TX you need to reverse the throttle channel.

[RoboKopter]

http://manuals.hobbico.com/fut/6ex-2_4ghz-manual.pdf - you need to look at page 10.. May as well save the pdf for later use as well.

I believe that all FASST recivers use the same generic pinout for the typical heli channels.

Don't forget to reverse the throttle channel.. Better yet- loosen the motor and make sure it does not mesh with the main gear- until you get everything setup.. Don't ask how I know..

PS: Someone beat me.. At least he will have the manual in pdf..