 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| Rotor Blades R/C Helicopter Rotor Blade Discussions |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
05-04-2012, 10:38 PM
|
#1 (permalink) |
|
Registered Users
Join Date: Oct 2010
|
Ok to fly with?
What do you think of these,was so windy tipped as it was spooling down.
|
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
05-07-2012, 10:46 PM
|
#2 (permalink) |
|
Registered Users
Join Date: Apr 2009
Location: Norway
|
Hard for me to see the damage on your blades, but attached is a pic of a 710mm Radix I still use.
Similar circumstances.
__________________
minicopter Diabolo, Henseleit TDR, X50e, X50n, Raptor 50 Futaba 2.4 GHz |
|
|
|
|
05-08-2012, 06:50 AM
|
#3 (permalink) |
|
Registered Users
|
Important place to check is the area of the blade that goes into the grip.Make sure there are NO cracks or stressed areas that can lead to a separation when spun up.
__________________
CX3,130X,Bergen Intrepid Gas & Turbine,Trex 800 Gasser HK600GT,HK500CMT,Goblin 770 Trex 800E |
|
|
|
|
05-15-2012, 02:23 PM
|
#4 (permalink) |
|
Registered Users
Join Date: Feb 2007
|
scuffs and nicks are fine so long as they're not through the CF and into the foam (or hollow core).
if you like, you can sand them out, and fill with CA or epoxy and rebalance Me, I'd fly and forget.
__________________
X-cell Fury 90: 601/9251, 8231's Cyc; DS650; OS 91MP-6; Jr Vibe 90; OS 91RJX Pipe; Jr 8231 cyclic, 770 3D/G8900, Prfct Reg. CCPM; T-Rex 600 NP: 6965HB, 425MG Throttle GY 520/9254; OS50 Hyper,MP-5, Prfct Reg; 600E Bstx, nue1910 |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
