Trex 550 hw 100a V3 platinum

[haas]

Hi, sorry for my englis :-)
I have HW Platinum 100A V3.
1/ I calibration trortle
2/I set governor store
3/ I set thortle curve 50%
4/ calibration ESC governor ( without main blade)
But when i use thortle curve 50% head speed 2400rpm and motor has 16500 rpm( max motor rpm are21420) Thortle curve no response power motor.(Thortle curve 50% but motor has 80% max power)

Is it normal?I would like use obout 2000 rmp head speed( thortle curve under 40% = ESC is OFF)
Where I take mistake in calibration governor ?

I need change pinion too.But motor plate has not big hole to near main gear. :-(

[racer-g]

You need to calibrate gov.(standartization) on 0 pitch,50% throttle and WITH blades.

[shultzee]

You need to go back through set up. Have the throttle curve at 0 through 100 for calibration (Normal) . Then set your idle 1 and idle 2 at straight line curve. Example; idle one 68 % straight across , Idle 2 78% straight across. After firing up heli you can put your stick at 50% (0 PITCH) and then hit idle 1 or 2 and off you go. Adjust your idle 1 or 2 to the head speed you are looking for.

[Thestructured]

Make sure when you try to recalibrate gov/store, you first put it to gov/elf and back into gov/store or it won't actually recalibrate itself.

[tonys-heli]

I always make the change, unplug lipo, then plug back in and change back to gov/store, and do the standardization. never missed yet..