governor problem set up

[billy no mates]

Hi every one,
got the new beastx plus,got it setup to my beloved 12x,but I'm struggling with the governor,its on a 700n dfc,start at the begging on setup A for gov test to see the sencers working,it is ,made sure the linkage is set right,it is ,set the idle in menu B,show the unit full throttle in menu C,then I move to menu D trans setup,on my 12x I like to use the gov funcsion on my set up,so I have it on aux 2 so I can control it with the stunt mode switch,i also have the throttle curve set at a line in normal(0to 100)s1 75% strate across,s2 100% strate across,but heres the problem it doesn't seem to go to full throttle,it just seems so sluggish,its seems I'm doing something wrong some ware ,but ware,the engine is a turn and a bit on the main needle so the engine isn't bogging,so heres to you ,help is needed
all the best from me

[bad007]

Got signal divider @ E set properly. LED off 1 magnet, 2 magnets purple flashing?

[billy no mates]

ya got that ,its all set as it should be ,maybe I'm over lookin someup,i don't no ,anyway thanks for the input

[bad007]

Since firmware 4.2 D shows rpms when you switch flight modes
http://wiki.beastx.com/index.php/Man...ernor_usage/en