START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Castle Creations ESC and Software Castle Creations ESC Software and Hardware Support |
|
LinkBack | Thread Tools | Display Modes |
12-06-2013, 10:39 AM | #1 (permalink) |
Registered Users
Join Date: May 2013
|
another auto bailoit setup help..
So... I have attempted to setup auto bailout but obviously im missing a step....
As far as i understand, i tick enable autorotation bailout, and after that i have to set my throttle curve to just below motor starting in in throttle hold... But i still get slow spoolup on startup. I dialled motor startup power to 10 but did not seem to help... Thing is, my throttle hold calibration seems strange.... Motor starts at 22%... I click back to 20, 18% to stop. Basically it takes around 3% margin where motor starts and cuts...as far as i know, i set up my throttle endpoints so that in msh brain it sees 0% - 100%.. |
Sponsored Links | |||
Advertisement |
|
12-07-2013, 03:32 AM | #2 (permalink) |
Registered Users
Join Date: Dec 2010
|
On initial start the ESC needs to see a 0 throttle to get it to arm and once armed it will soft start.
When you hit TH it need to be low enough to take power off the motor but not too low it rearms the ESC and makes it soft start. Some reading material http://www.castlecreations.com/suppo...ernor_mode.pdf http://www.castlecreations.com/suppo..._endpoints.pdf http://www.castlecreations.com/suppo...o_rotation.pdf |
12-09-2013, 05:46 AM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: May 2013
|
thanks for the links... but now is another problem... im using dx8, after manually calibrating end points, i ended up with -90 something and +120 something throttle instead of -130+130 like im supposed to set for brain controller to see -100+100 throttle... is that normal?? i think im loosing like 30% of throttle for my brain... any way to auto-calibrate in governor mode?
but at least bailout seems to work lol... |
12-09-2013, 06:15 AM | #4 (permalink) |
Registered Users
Join Date: Feb 2011
Location: Australia
|
Dude!
If your using the GOV in the castle then disregard the throttle in the BRIAN/TRAX/IKON. It is now just passing the signal through. In my DX8 my low is at 127 and my high is at 118 My throttle hold is not set to 17 across the 5 points, that is when the motor stops while setting up auto-bailout. hope this helps, cheers
__________________
Rapid Helis Australia |
12-09-2013, 07:43 AM | #5 (permalink) | |
Registered Users
Thread Starter
Join Date: May 2013
|
Quote:
|
|
Thread Tools | |
Display Modes | |
|
|