START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
RealFlight Flight Sim All versions of RealFlight Sim |
|
LinkBack | Thread Tools | Display Modes |
02-07-2013, 07:14 AM | #1 (permalink) |
Registered Users
Join Date: Mar 2008
|
Interlink sticks dead around center Quick Fix!
If your Interlink Elite rudder and aileron sticks seem Dead or sloppy around center here's the fix.
The problem is the detent spring is levering the gimbal assembly apart. Read this, trial fit everything a couple times so you get the feel fore how everything goes back together as you only have about 30 seconds to reassemble the gimbal before the CA sets Remove the 4 screws on the back of the interlink set the back aside. Grasp this piece just as shown and pull with your thumb (It is attached at the top with a locater boss). The culprit, pop this out and set aside, Using medium CA, place ONE small drop on this pin, The V shaped piece goes on the pin first then the gimbal back, quickly reassemble the gimbal before the CA sets (This is why Medium or thick, extra working time), cycle the offending stick and your good. Done, 3 minute repair and you're back flying!
__________________
Find me on Facebook https://www.facebook.com/wiley0717 Last edited by Will Holland; 02-07-2013 at 05:15 PM.. |
Sponsored Links | |||
Advertisement |
|
02-09-2013, 11:10 AM | #2 (permalink) |
Registered Users
Join Date: Apr 2012
|
Won't that void your warranty?
|
02-10-2013, 06:35 AM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Mar 2008
|
Sure will, I got second hand so no warranty for me
This was the result from a drop anyway, working on another fix rather than a work around and I have managed to land face down again lol.
__________________
Find me on Facebook https://www.facebook.com/wiley0717 |
Thread Tools | |
Display Modes | |
|
|