Outrage Velocity 50, Align Governor i Turnigy 9X How to setup everything?

[Aszczepo]

Hi all!

I'm looking for help. My problem is that the governor is setup right ( I have done everything with with governor manual ) but still engine spins up to 20.000 RPM while curve reach ~10%. I don't know what to do? Maybe somebody can help me?

Outrage Velocity 50N Maiden Hover (1 min 31 sec)

- here is the video with first flight. There you can hear RPM

Thanks

[morganr33]

what is your gov. gain set at?

[memosteve]

Are you controlling the gain through the radio?

You need to turn the gain down...Probably to about 70%, if you're running 100%.

The manual for the Align governor is set up for running Align gearing/magnet placement on Align helis...The math for the Outrage will not be the same!

I ran the same governor on my Velo, and I had to use different gain values compared to the Align setup...

Anyway...I wouldn't run that head speed/motor rpm that high...You're asking for trouble!

P.S. Radio also makes a difference, but I'm sorry...I don't have any knowledge/experience with the radio you're running...I would still start with using less gain though!

[Aszczepo]

Thanks. You helped me a lot. I will check everything