GPRO HELP NEEDED

[MikeS1944]

Think I have major problem. I had gotten to the point where the Gpro was set up, the Talon was set up, motor was rotating in the correct direction. I had shut everything down to install the rear blades so I could set up the 10 mm deflection called for in the manual. I turned the transmitter back on, powered up the ESC which did it's usual beeping and tried to move the rear blades. Nothing was moving. Then I realized that my receivers were not lit (DSMX). So I assumed I had lost bind for some reason. I initiated the software and plugged in a battery to the Gpro but it is not responding. I tried two different batteries. The light on top of the Gpro is NOT lighting up. I am at a loss. Everything was working fine and then boom nothing works. Any help will be greatly appreciated.

[jumatic]

Had same issue. Just check wiring. Sometimes it helps first wiring esc bec plug directly to gpro thr batt in. And then to rx data bind for power. If this doesnt work sth could be broken