Register Now

RC'er · 08-29-2010, 04:14 PM

I am sending back my ICE 100 esc (loose heat sink) and putting the stock esc back on. How well does the stock RCE-BL70G ESC work using governor mode?

bobkra · 08-29-2010, 04:45 PM

I tried mine in "G" mode and it held a constant speed very well, but I could never get the speed to be where / as high as I wanted it. I use throttle curves instead.

Wolfpackin · 08-29-2010, 05:29 PM

Align ESC's are known to have marginal governor modes.
Just run a shallow V, or flat, curve and I'm sure that will hold you over quite well.

helikev2 · 08-29-2010, 09:18 PM

i 've always wanted to ask that question. thanks!

but does that add extra workload to the ESC that it heats up more?

Nko15 · 08-30-2010, 05:37 AM

Short answer: Its crap. tested it on both the 70 and 100 amp align esc, and 1, the tail gets ticks(not a gyro+servo problem...)and it just doesnt hold the rpm's right.. at least not during soft 3d..

08-29-2010, 04:14 PM	#1 (permalink)
RC'er Registered Users Join Date: May 2010	Stock RCE-BL70G ESC governor mode? I am sending back my ICE 100 esc (loose heat sink) and putting the stock esc back on. How well does the stock RCE-BL70G ESC work using governor mode? __________________ Scott Trex450 sport -- Trex550 FBL -- Swift NX

08-29-2010, 05:29 PM	#3 (permalink)
Wolfpackin HF Support My HF Map location Join Date: Nov 2007	Align ESC's are known to have marginal governor modes. Just run a shallow V, or flat, curve and I'm sure that will hold you over quite well. __________________ Jonathan Livingston Helicopter Blade 400: E-flite 420H/35X ESC, AR6100e, HS65HB x 3, G401B/DS290G. (Ret.) CopterX 450AE V2: 430XL/35X ESC, AR6100, HS65HB x 3, LTG2100T/HSG-5084MG. T-Rex 550E V1 Classic Flybar: 600MX/BL70G, AR6200, DS610 x 3, Quark/DS650, 16t/520mm blades.

08-29-2010, 09:18 PM	#4 (permalink)
helikev2 Registered Users Join Date: May 2008	i 've always wanted to ask that question. thanks! but does that add extra workload to the ESC that it heats up more? __________________ Trex 450 Pro for 3D

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-29-2010, 04:45 PM	#2 (permalink)
bobkra Registered Users Join Date: Apr 2008	I tried mine in "G" mode and it held a constant speed very well, but I could never get the speed to be where / as high as I wanted it. I use throttle curves instead.

08-30-2010, 05:37 AM	#5 (permalink)
Nko15 Registered Users Join Date: Jan 2010	Short answer: Its crap. tested it on both the 70 and 100 amp align esc, and 1, the tail gets ticks(not a gyro+servo problem...)and it just doesnt hold the rpm's right.. at least not during soft 3d..

Register Now

Log-in