New Vibration Absorbing Kit for DJI 4114 Motors

[DJI Innovations]

The new vibration absorbing kit for your DJI 4114 motors helps reduce unwanted vibrations that may be caused by your motors. The package contains new soft dampers and new motor screws designed to absorb high-frequency vibrations and prevent them from reaching your IMU and gimbal. To install the new items, simply unscrew the old motor screws and remove the old dampers. Then put the new dampers in place and tighten the new screws.

Note: The new soft dampers must be used with your original metal gaskets and the new motor screws.

Suggested gain value settings when using a DJI S900 with the new vibration absorbing package are below.

For A2 flight control systems:
Basic: Pitch 120%, Roll 120%, Yaw 120%
Attitude: Pitch 190%, Roll 190%, Vertical 120%

For WooKong-M flight control systems:
Basic: Pitch 130%, Roll 130%, Yaw 120%
Attitude: Pitch 190%, Roll 190%, Vertical 120%



Where to buy: DJI authorized dealers

[daneger21]

Will these be included in any new s900 kits?

[clouseau]

Of the two S900 I worked on, neither of the two had any vibration issues...

Is this an issue others are reporting?

[daneger21]

Originally Posted by clouseau

Is this an issue others are reporting?

+1

Thinking of getting one myself and would like to know

[setishock]

If there's vibes being passed on to the frame from the motors would it not be prudent to check the balance on the motors themselves? And also balance the blades?
I'd think fix the problem instead of putting a band aid on it.

[Lubebosch]

Do they also work on the S1000 Premium?
It has the same motors.
Would it be good?
Thanks

[Tahoe Ed]

Get the ones for the S900. They include the brass hole liners that make the rubber dampeners last longer. They work on the S900 and the S1000.