START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Electric Motors, Gearing, Speed Controls, Gyros, Receivers, and Other Electronics Discussion Electric Motors, Gearing, Speed Controls, Gyros, Receivers and Other Electronics Discussion |
|
LinkBack | Thread Tools | Display Modes |
05-02-2010, 11:07 AM | #1 (permalink) |
Registered Users
Join Date: Feb 2007
|
Govenor Magnets / Installation
I replaced the plastic fan with an Aluminum upgrade on my Raptor. When I installed my Magnets. I in-advertantly installed them both Positive side Down toward sensor.
I know that Some Governors, throttle jockeys etc need to have 1 positive polarity down and 1 neg polarity down so it does not read them both and thrash the settings. I have the Futaba GV-1 and when I rotate it, I am getting Sensor reading on the pickup magnet of 97% and then the other comes around and it only registers 4 - 5%. I believe this govenor is only reading the one magnet but the book states to mount the opposite balancer magnet with opposite polarity. Should I need to dismantle this thing and drill it out to put in opposite way. Thank you[8|]
__________________
Electrics - Hummingbird V2: Helimax MX-400: EXI 450: Nitros - Raptor 50 Titan SE: X-Cell 60 Graphite SE |
Sponsored Links | |||
Advertisement |
|
05-02-2010, 11:10 AM | #2 (permalink) |
Registered Users
Join Date: May 2004
|
well, something isn't quite right because the GV1 sensor is only sensitive to 1 magnetic pole.
so, if you really put them in the same side 'up', then it should read 97% or so for both. If it's only reading 4-5%, then you should be OK. |
Thread Tools | |
Display Modes | |
|
|