Trex600fl head on 600esp

[jake2555]

Hey guys ive been trying to search this for over a week now. Lol. Anyways im looking to convert my trex600esp to fbl and trying not to go to dfc. What im asking is will the trex600fl head fit on the trex600esp. If so what shaft.

[Gladius]

Here is what I found at A-Main Hobbies.

Note: This rotor head system must be used with the Align 550E Main Shaft Set (AGNH55006), 600PRO Metal Main Rotor Holder (AGNH60204) and 600 Feathering Shaft (AGNH60H001XXW) or Feathering Shaft (AGNH60006).

[jake2555]

This is the head im after.

[Gladius]

Here's what I found on Experience RC's website:

H60H003XX 600FL Flybarless Rotor Head System
Suitable for T-REX 550 / 600. Must with 600 Main Shaft Set(H55006)、600PRO Metal Main Rotor Holder(H60204)、600 Feathering Shaft(H60H001XXW) or (H60006)

[goodhunting]

yes it works. I beefed up my older ESP and simply replaced the head with a FBL one (non DFC)....
I reprogrammed the gyro (as it now needs a FBL gyro) and off I went..
no issues ever since...

I have a DFC head as well for another ESP... and that one requires a lower main shaft as teh links on the DFC head are smaller...

it can be done

gh

[jake2555]

Okay good). One more question, what shaft did you use? Esp shaft?

[SumOFparts]

Three shafts fit the non-3rd bearing 600's

dfc - 163mm
E's, FL's - 177 mm
and the old Fly bar ones - 192mm



According to this -

http://www.amain.com/rc-helicopters/...h003xx/p387004

You need this one (the 177mm one) -

http://www.amain.com/rc-helicopters/...h55006/p178501

[goodhunting]

for the non DFC head I used the standard ESP main shaft... (all I did was swap the head and gyro)..

for the DFC one the main shaft is "custom cut" to fit the DFC links... but you can use the smaller main shaft with no issues...

gh