Register Now

Shogun71 · 08-20-2016, 06:02 PM

Man, it's been a long time since I set one of these up.

I swapped in a Jeti receiver in a plane but now the esc is acting like it's set up for heli use. Very slow startup and spool up after killing the throttle. Not the best on an acrobatic plane....

I guess I'll have to reprigram the esc...

Update. When I did the throttle calibration with the sticks it must have reset a few parameters. Brake was enabled, startup speed was heli middle, and a few other things were off.

Now updated and good to go. Throttle much more responsive now.

snemi00 · 08-20-2016, 10:34 PM

Yup.
Complete reset, like a Kontronik Mode 1

KevinB · 08-21-2016, 07:52 AM

Interesting. That must be something included in a more recent firmware. None of my YGE controllers used to reset all the settings after doing an endpoint calibration...........however I just got a YGE160HV back from YGE service, and I had the settings get wiped twice on me while setting it up. Now that I see this, it DID correspond to the two times I reset the endpoints.
Good to know.

KevinB

08-20-2016, 06:02 PM	#1 (permalink)
Shogun71 Registered Users My HF Map location Join Date: May 2012	Does throttle calibration reset the esc? Man, it's been a long time since I set one of these up. I swapped in a Jeti receiver in a plane but now the esc is acting like it's set up for heli use. Very slow startup and spool up after killing the throttle. Not the best on an acrobatic plane.... I guess I'll have to reprigram the esc... Update. When I did the throttle calibration with the sticks it must have reset a few parameters. Brake was enabled, startup speed was heli middle, and a few other things were off. Now updated and good to go. Throttle much more responsive now. __________________ Jeti DS-16, Oxy 3, Goblin 380, 500, 630, and 700 competition, Airwolf 600 scale heli, Brain/Ikon 2, Spartan VX1e, Sk 720, YGE and Hobbywing. Last edited by Shogun71; 08-20-2016 at 08:43 PM..

08-20-2016, 10:34 PM	#2 (permalink)
snemi00 Registered Users Join Date: Jan 2010	Yup. Complete reset, like a Kontronik Mode 1 __________________ SAB Heli Division Rotorquest

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

08-21-2016, 07:52 AM	#3 (permalink)
KevinB Registered Users Join Date: Apr 2004	Interesting. That must be something included in a more recent firmware. None of my YGE controllers used to reset all the settings after doing an endpoint calibration...........however I just got a YGE160HV back from YGE service, and I had the settings get wiped twice on me while setting it up. Now that I see this, it DID correspond to the two times I reset the endpoints. Good to know. KevinB

Register Now

Log-in