START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
mSR Blade (eFlite) Micro SR Helicopters Information and Help |
|
LinkBack | Thread Tools | Display Modes |
04-30-2012, 01:53 PM | #1 (permalink) |
Registered Users
Join Date: Feb 2012
|
MSR Servo
Hi Guys, Has anyone had cause to change a servo on an MSR ?
How difficult is it ? I am a bit concerned about the soldered wire connections. I have a pretty small soldering iron but I am concerned about damaging the control board. Any ideas or advice ? Cheers Bob |
Sponsored Links | |||
Advertisement |
|
04-30-2012, 06:12 PM | #2 (permalink) |
Registered Users
Join Date: Mar 2010
|
If the motor is good, go this route.
Unscrew the servo. Carefully pop the motor out of the servo frame Carefully put the old motor into the new servo frame. Screw the servo onto the 5n1. No soldering needed!
__________________
Syma S107-Syma S109-Syma X8C-Syma X8G-Syma X5HC-Syma X5HW-Mini Orion-ProtoX-Syma X5C-1 USAF RETIRED 1968-1988 Vietnam Veteran |
05-02-2012, 02:42 PM | #3 (permalink) |
Registered Users
Thread Starter
Join Date: Feb 2012
|
Many thanks for that idea. It solves all my problems with soldering.
Cheers Bob |
05-02-2012, 06:08 PM | #4 (permalink) |
Registered Users
Join Date: Mar 2010
|
No problem!!! I hate soldering too...my 63 year old eyes are not as good as they used to be.
__________________
Syma S107-Syma S109-Syma X8C-Syma X8G-Syma X5HC-Syma X5HW-Mini Orion-ProtoX-Syma X5C-1 USAF RETIRED 1968-1988 Vietnam Veteran |
Thread Tools | |
Display Modes | |
|
|