Register Now

Trex_700N · 05-05-2012, 11:36 PM

Hey everyone, on my 600 EFL Pro I'm running a Castle BEC on it. If I were to run High Voltage (HV) servos on it can I do away with the BEC? Any help would be appreciated, Thank You all.

teshreve · 05-06-2012, 12:56 AM

If you are using it as a BEC, no.
If you are using it as a regulator and have a RX pack, yes.
But there are caveats

HV servos can be connected directly to 2S Lipo voltage.
Can the rest of your electronics handle 8.4v?

You could optionally set your Castle BEC to ~8.0v and not use an RX pack.

05-05-2012, 11:36 PM	#1 (permalink)
Trex_700N Registered Users Join Date: Nov 2011	High Voltage (HV) Servos Hey everyone, on my 600 EFL Pro I'm running a Castle BEC on it. If I were to run High Voltage (HV) servos on it can I do away with the BEC? Any help would be appreciated, Thank You all.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-06-2012, 12:56 AM	#2 (permalink)
teshreve Registered Users My HF Map location Join Date: Jun 2007	If you are using it as a BEC, no. If you are using it as a regulator and have a RX pack, yes. But there are caveats HV servos can be connected directly to 2S Lipo voltage. Can the rest of your electronics handle 8.4v? You could optionally set your Castle BEC to ~8.0v and not use an RX pack.

Register Now

Log-in