3 Axis/RX board not level ( Having trouble with flips and piros?)

[rallyant]

Anyone else experienced this?

On flips the heli seemed to roll and yaw out, required constant correction. I noticed the 3axis board was not level on my 130

I used some foam tape as a spacer to level it
And now its nice and flat


I left it for a while as it was fine with "normal" flight. And i wanted to get a good feel for the heli so i could pick up any subtle changes leveling the board might make. BIG mistake. Its night and day! Its soooooo much nicer now. It flips straight, and the piros are much flatter. Even with 460mha nose heavy packs.

I really struggled to do half piro flips (always do ) but it now does them as easy as my 600... almost

Sent from my Galaxy Nexus using Tapatalk 2

[d12bn]

Mine was the same but can't seem to get it perfectly level. Did you pull yours out to level it?

[rallyant]

Yeah I had to pull it out.
Once the skids are off you can move it. But it always went back on an angle. Have to physically have something holding it where you want it. I think my foam will crush over time and I'll have to do something else eventually.
The fact this thing just will not sit right with the esc and battery wires pushing on the frame, makes me wander just how many others are actually level?

Sent from my Galaxy Nexus using Tapatalk 2