Register Now

sethb · 08-31-2015, 08:05 PM

Just installed a new edge 120 cc hv on my trex 550l everthing went fine however when it spools up it is way to slow could someone give me some idea how to correct this problem i like slow spool up but this is way to slow. I have been in the setting in the software and set the spool up to high but guess i must be doing something wrong.

FNFAL · 09-01-2015, 01:30 PM

Strange indeed. You can also play with motor start power as well. And make sure you're not accidentally in any hi/low gov mode also. Throttle channel properly calibrated also?

RC/DC_5000 · 09-09-2015, 02:29 PM

It's likely a problem with the calibrated endpoints.

Thestructured · 09-09-2015, 11:02 PM

Make sure when you change the settings you actually hit save settings.

sethb · 09-11-2015, 07:33 PM

I change the settings on the motor to outrunner instead of 12hz really done the job, spool up was already on high as well as everything else.

thanks for all the help.

SumOFparts · 09-12-2015, 08:22 AM

Did you update to latest firmware?

-

sethb · 09-13-2015, 08:34 PM

I think there is a update i don't have will check.

08-31-2015, 08:05 PM	#1 (permalink)
sethb Registered Users Join Date: Apr 2014	Trex 550L spool up. Just installed a new edge 120 cc hv on my trex 550l everthing went fine however when it spools up it is way to slow could someone give me some idea how to correct this problem i like slow spool up but this is way to slow. I have been in the setting in the software and set the spool up to high but guess i must be doing something wrong.

09-09-2015, 11:02 PM	#4 (permalink)
Thestructured Registered Users Join Date: Dec 2014	Make sure when you change the settings you actually hit save settings. __________________ Trex 700L spirit pro / Trex 700n spirit pro/ Trex 550x spirit pro / Goblin Black Nitro 700

09-12-2015, 08:22 AM	#6 (permalink)
SumOFparts Registered Users Join Date: Mar 2013	Did you update to latest firmware? - __________________ Reach farther...

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

09-01-2015, 01:30 PM	#2 (permalink)
FNFAL Registered Users Join Date: Oct 2012 Location: Dayton Ohio	Strange indeed. You can also play with motor start power as well. And make sure you're not accidentally in any hi/low gov mode also. Throttle channel properly calibrated also?

09-09-2015, 02:29 PM	#3 (permalink)
RC/DC_5000 Registered Users Join Date: Jan 2015	It's likely a problem with the calibrated endpoints.

09-11-2015, 07:33 PM	#5 (permalink)
sethb Registered Users Thread Starter Join Date: Apr 2014	I change the settings on the motor to outrunner instead of 12hz really done the job, spool up was already on high as well as everything else. thanks for all the help.

09-13-2015, 08:34 PM	#7 (permalink)
sethb Registered Users Thread Starter Join Date: Apr 2014	I think there is a update i don't have will check.

Register Now

Log-in