subtrim or not

[bad007]

Originally Posted by anthony1

thank you, just going to go and spool it up and iy started raining so this is a good time to triple check everything

LMAO, I've been out in the rain with mine all morning, the 3GX on top, behind the antirotation bracket got two specks of water on it and that's all

[anthony1]

so i did finally get to give it a go, just a quick flight at the park and everything went very smoothly, i would like to tame the tail a bit not around centre but the actual piro rate, at full deflection i had trouble seeing it, is that an atv adjust or is there something in the software to limit the rudder rotation, flip and roll rate are a little fast too but that can wait, ok, so what i did notice ,and it was a little windy , is a bit of porpoising with fff and collective up and down what setting is it to change that?

[anthony1]

oh and the rain we had was more of a downpour for about half an hour then light rain after that, tried to get out but it is mothers day so i ended up washing floors and dishwashing oh and dinner, the kids didn't help(surprise) then i went out

[bad007]

Originally Posted by anthony1

so i did finally get to give it a go, just a quick flight at the park and everything went very smoothly, i would like to tame the tail a bit not around centre but the actual piro rate, at full deflection i had trouble seeing it, is that an atv adjust or is there something in the software to limit the rudder rotation, flip and roll rate are a little fast too but that can wait, ok, so what i did notice ,and it was a little windy , is a bit of porpoising with fff and collective up and down what setting is it to change that?

Piro to fast, if rudder acceleration is 0 use atv.
Flip and roll rate a little to fast, lower control rate for aileron and elevator by 5
Porpoising gain to high or to low, usually around 1:00 on the gains are good, onething during setup if you use TH you must be sure TH is set to 0 or it messes with your setup and causes problems with the collective mixing with the cyclic. By default spek. TX is set to -5

[anthony1]

again i thank you