Breast x drift

[3dflyboy09]

i have a trex 450 pro v2 flys great but is alway drifting backward ar7200bx says to not use any trim so how can i stop the drift.

[Bob O]

Originally Posted by 3dflyboy09

i have a trex 450 pro v2 flys great but is alway drifting backward ar7200bx says to not use any trim so how can i stop the drift.

What kind of mounting tape are you using? You might consider a velcro strap around the FBL unit.

[3dflyboy09]

just using stock but will try strap could swash levelness or cg play a roll in this swash seem pretty good to my naked eye though

[crf69]

i recommend 3M 4011 2-sided tape.

red backing with grey sticky

[cpmboy]

upps....sorry ...I though a new category.....''''breast x...".....

[infamousnation]

You probably will want to get a tool for leveling your swash, it's worth it. Checking cg is pretty easy, just pick the heli up by the blade grips and then hold it so the main shaft is parallel to the ground. It should not tilt forward or back. Checking for vibes is pretty easy. Take off main blades and tail blades. Spool up the heli and run it at different speeds. Watch for any servo movements. The littlest vibration can cause the beastx to think the heli is rotating when it's not.

[highlightshadow]

Well, assuming you setup menus G, I, J, K, L & M ok for swashplate levelling, geometry and limits etc

Then you use parameter menu A to adjust like you would sub-trim assuming you cannot shift your battery forward for example to adjust the CoG forward to counter back drift.

Hope you get it sorted!

[tomd27858]

Originally Posted by highlightshadow

Well, assuming you setup menus G, I, J, K, L & M ok for swashplate levelling, geometry and limits etc

Then you use parameter menu A to adjust like you would sub-trim assuming you cannot shift your battery forward for example to adjust the CoG forward to counter back drift.

Hope you get it sorted!

+1 and check your swash with a leveler.

[fuzzyllamma]

If none of these work, try going into setup parameter E (stick deadband) and reducing it. I had a similar issue and one click down solved my problem. You may need to go more or less. It could also no solve your problem but try it if all else faile

[GeKu]

Your "Breast x"? Are you sure it is drift, and not bounce? lol sorry I couldn't resist

[Harbormaster]

Originally Posted by 3dflyboy09

i have a trex 450 pro v2 flys great but is alway drifting backward ar7200bx says to not use any trim so how can i stop the drift.

Have you tried an underwire bra for better support?

[chrismechanic]

or a sport bra could help...so the wife says