START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
RealFlight Flight Sim All versions of RealFlight Sim |
|
LinkBack | Thread Tools | Display Modes |
04-05-2014, 10:15 AM | #1 (permalink) |
Registered Users
Join Date: Jun 2010
|
Heli Hover Training -How to edit the startup script
Just upgraded to RF7, working on getting all the hover orientations smoothed out. However, the standard heli that gets loaded is the Dominion 3D gasser, I'm looking for am electric to get loaded automatically instead of manually loadAicraft command.
If I pull up the command line, there is a scrip being executed. Here is what shows... exec startup Executing Script Done executing script -Heli Picture- Loaded: Dominion 3D Where is this script and how is it edited? I'm sure if I could find the script, the name of what ever aircraft you want to use as your training bird could be substituted and that would load every time. |
Sponsored Links | |||
Advertisement |
|
04-06-2014, 10:16 AM | #2 (permalink) |
Registered Users
Thread Starter
Join Date: Jun 2010
|
There is a startup script.
When I first opened it, it was empty except a few comments. I added loadVehicle Align T-Rex 700E PRO DFC HV This heli now loads on startup up, but that does not carry over yo the heli hover trainer... Hmmmm. |
04-06-2014, 07:36 PM | #3 (permalink) |
HF Support
|
If you script starts "trainer_heli_hover", then "loadVehicle Align T-Rex 700E PRO DFC HV", it will put the Align T-Rex 700E in the hover trainer. (But since the start point is incorrect it will explode until to reset using the red button.
You can also add windSpeed and windTurbulence for extra challenge (and adjust the camera_zoom_type and camera_zoom if you like). I have not tried to adjust the airport after loading the trainer.
__________________
TRex 700E Pro DFC HV (BD3SX) - Gaui X5 (6S/BD3SX), Blade 130X, RealFlight, Heli-X, Taranis+DSMX |
Thread Tools | |
Display Modes | |
|
|