 |
START HERE |
|
| Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
|
|
|
Unregistered
|
||||||
| mCP X Brushless Mods Blade Micro CPx Brushless Mods and Conversions |
|
|
 |
|
|
LinkBack | Thread Tools | Display Modes |
04-16-2012, 01:10 AM
|
#1 (permalink) |
|
Registered Users
Join Date: Jul 2010
|
Flashed xp12a and hp08s stalls on start up?
Wazzup? Just got stuff soldered up and test ran motor without blades and it spooled up nicely...then put blades on and not it stutters and stops quickly. If I try to start it a couple more times it still stutters and esc gets hot. WTF???? Any advice would be helpful. Thx
|
|
|
| Sponsored Links | |||
|
Advertisement |
|
||
|
04-16-2012, 01:13 AM
|
#2 (permalink) |
|
Registered Users
Thread Starter
Join Date: Jul 2010
|
Solder looks good, motor screws shortened,mesh good
|
|
|
|
|
04-16-2012, 01:21 AM
|
#3 (permalink) |
|
Registered Users
Thread Starter
Join Date: Jul 2010
|
I loosened up the blades grips and now it starts to spool up but quits after a few seconds
|
|
|
|
|
04-16-2012, 03:15 AM
|
#4 (permalink) |
|
Registered Users
Join Date: Nov 2008
|
Lipos?
Gear mesh too tight? Amp |
|
|
|
|
04-16-2012, 03:19 AM
|
#5 (permalink) |
|
Registered Users
Thread Starter
Join Date: Jul 2010
|
Brand new hype 550s, gear mesh fine
|
|
|
|
|
04-16-2012, 01:48 PM
|
#6 (permalink) |
|
Registered Users
Join Date: Apr 2010
|
Good connectors, wiring and short connections? Micro Deans, at least 24AWG wire. Solder directly to motor from ESC and Battery directly to ESC then jumper to main board for power. The stock 26AWG wire and connectors are too wimpy for beefed up motors.
YMMV, Don |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
