3 n1 replacement

[chip'n'fly]

I have an mcpx well 2 actually, both with blown tail FETs... what is the best route to fix this? I have a solder gun but haven't used it yet so needless to say, I'm probably not to good with it!

[jpauze]

For some reason i can't search the forum but go through the mCPx forum posts as i know i have seen instructions somewhere as well as threads with where to send for repair when you have blown the FET.

These are way too small to solder for my old eyes.

[Naito]

I'd say convert them to dual brushless, but that's me =D I don't think the fets should be too hard to replace, but if you've not used a soldering iron before you'll want to practice on something else first.

[lil-bump]

http://www.megasmicros.com/ = problem solved